The curve grinding machine should be maintained and used by designated personnel, and regular inspections should be carried out to ensure that the machine tool is in good condition.
1. After the operation is completed, all parts of the machine, especially the sliding parts, should be wiped clean and then oiled.
2 Remove the grinding chips from all parts of the grinding machine.
3 Anti-rust treatment should be applied to necessary parts.
Precautions for maintaining the above grinding machine:
1. Before grinding, please correct the balance of the grinding wheel.
2 The grinding wheel must be carefully selected based on the material and hardness of the workpiece.
3 A thin oil film should be applied to the spindle end and the flange of the grinding wheel to prevent rust.
4. Please pay attention to the rotation direction of the main shaft.
5 The use of air guns to clean crops and machines is prohibited.
7. Please pay attention to whether the oil window and oil passage are smooth.
10. Vacuum box, filter steel, please clean once a week.
11. When the suction power is weak, please check if there is any powder or debris blocking the suction pipe.
twelve The suction pipe must be kept clean; otherwise, it may cause a fire.
1.1 Maintenance of grinding machine suction cups
The surface of the permanent magnetic cast chuck or electromagnetic chuck is the basis for determining the grinding accuracy of the workpiece and should be properly maintained and cared for. If the precision of the workpiece is poor or the disc surface is damaged, the disc surface must be ground again. Only when the precision of the disc surface meets the requirements can the precision of the workpiece be ensured.
1.2 Maintenance of the grinding machine lubrication system
The lubricating oil should be replaced after the first month of use, and then every 3 to 6 months. There is an oil drain plug at the bottom of the oil tank, which can be utilized. Please note that when changing the oil, clean the inside of the tank and the filter at the same time.
